Razor Electric Motor- E200, E225, E275 by Universal Parts

Restore original top speed and climbing torque to your Razor electric scooter with the Universal Parts 24V 200W Chain Drive Motor. This MY1016 permanent magnet brushed motor features full ball-bearing construction and high-density carbon brushes for long service life and stable power delivery. The 10-tooth sprocket for #25 chain is factory-installed on the 8mm left-hand-threaded shaft, and the 19-inch wire leads with quick-connect terminals route directly to your controller block.

Version fitment note: This is a chain-drive motor for Razor E200 / E225 versions 5 and up. It will not fit versions 1–4, which use a belt-drive configuration. To confirm your version, locate the barcode ID tag on the bottom of the frame — the 7th and 8th digits must be 05 or higher.

Key Features

• MY1016 permanent magnet brushed motor — full ball-bearing construction for low heat and long life
• High-density carbon brushes — stable voltage delivery and extended brush lifespan
• Factory-installed 10-tooth sprocket for #25 chain — no sprocket swap required
• 8mm left-hand-threaded shaft — matches OEM Razor chain-drive configuration
• Reversible rotation — swap direction by reversing positive and negative leads
• 19-inch wire leads with quick-connect terminals — direct controller block connection

Specifications

• Model: MY1016 / MY1016-II-1
• Voltage: 24V DC
• Output Power: 200W
• Rated Speed: 2750 RPM
• Rated Current: 11A
• Sprocket: 10-tooth, #25 chain
• Motor Body Diameter: 101mm (~4")
• Mounting Bracket Bolt Pattern: 104mm diagonal
• Shaft: 8mm diameter, 30mm length, left-hand thread
• Wire Leads: 19 inches, quick-connect terminals
• SKU: 119-160 | MPN: W13112099030

Compatibility

Installation tip: When fitting the motor bracket, verify chain alignment. A misaligned chain accelerates sprocket wear and can draw excess current, tripping the controller reset or blowing the inline fuse.

California Prop 65 Warning: www.p65warnings.ca.gov

• MY1016 permanent magnet brushed motor with full ball-bearing construction
• High-density carbon brushes for stable voltage and long brush life
• Factory-installed 10-tooth #25 chain sprocket - no swap required
• Reversible rotation by swapping positive and negative leads
• 19-inch quick-connect wire leads for direct controller connection

Model: MY1016/MY1016-II-1 | Voltage: 24V DC | Power: 200W | Speed: 2750 RPM | Current: 11A | Sprocket: 10T #25 chain | Body OD: 101mm | Bracket: 104mm diagonal | Shaft: 8mm x 30mm LH thread | Leads: 19" | SKU: 119-160

Razor E200/E200S (V5+); Razor E225 Cruise (V5+); Razor E275 (all versions); Razor RX200 Rugged Terrain (all versions)